このアイテムのアクセス数: 222

このアイテムのファイル:
ファイル 記述 サイズフォーマット 
A010035SI1226.pdf548.37 kBAdobe PDF見る/開く
タイトル: A long-term control scheme of cutting forces to regulate tool life in end milling processes
著者: Ibaraki, Soichi  kyouindb  KAKEN_id
Shimizu, Takuya
著者名の別形: 茨木, 創一
キーワード: Tool life
End milling
Cutting force
Feedback Control
Feedrate scheduling
発行日: Oct-2010
出版者: Elsevier Inc.
誌名: Precision Engineering
巻: 34
号: 4
開始ページ: 675
終了ページ: 682
抄録: Numerous researches on cutting force control in end milling processes have been reported in the literature. There have been, however, very few practical applications actually employed in commercial products. The paper presents a simple, practically feasible and effective scheme to regulate the tool life through a long-term control of cutting force. Cutting force changes quickly occurring due to tool path geometry are suppressed using model-based feedrate scheduling. Cutting force is monitored only at tool path check points, set typically at intervals of several dozen meters. Since it does not require continuous full-time monitoring of cutting forces, a “cheaper” estimation scheme of cutting forces can be potentially employed. Feedback control focuses only on a long-term point-to-point regulation of cutting force, targeting tool life providing cutting for the given desired distance. The effectiveness of the present approach is experimentally investigated by an application example to contour-parallel cutting of hardened steel.
著作権等: © 2010 Elsevier Inc.
この論文は出版社版でありません。引用の際には出版社版をご確認ご利用ください。This is not the published version. Please cite only the published version.
URI: http://hdl.handle.net/2433/126733
DOI(出版社版): 10.1016/j.precisioneng.2010.05.001
出現コレクション:学術雑誌掲載論文等

アイテムの詳細レコードを表示する

Export to RefWorks


出力フォーマット 


このリポジトリに保管されているアイテムはすべて著作権により保護されています。