このアイテムのアクセス数: 163
このアイテムのファイル:
ファイル | 記述 | サイズ | フォーマット | |
---|---|---|---|---|
j.procir.2018.08.225.pdf | 855.87 kB | Adobe PDF | 見る/開く |
タイトル: | Influence of contact condition between flexible plate and passive pivot support on machining vibration |
著者: | Matsubara, Atsushi ![]() ![]() Nagai, Hiroaki Knorr, Nils Kono, Daisuke ![]() ![]() ![]() |
著者名の別形: | 松原, 厚 河野, 大輔 |
キーワード: | machining vibration support damping contact condition |
発行日: | 2018 |
出版者: | Elsevier BV |
誌名: | Procedia CIRP |
巻: | 77 |
開始ページ: | 557 |
終了ページ: | 560 |
抄録: | A passive support with a pivot mechanism was previously designed for increasing damping of the vibration modes of a flexible structure. Here, to investigate the influence of the contact conditions between the pivot support and a flexible plate, the contact area is discretised into line contacts using metal rollers. The effect of contact stiffness is also investigated using additional plastic rings. Impact hammering tests are conducted and measured dynamic compliances are compared. Machining tests are subsequently performed to confirm vibration suppression. The line contacts are found to exhibit good vibration suppression capability in both the vibration and machining tests. |
著作権等: | © 2018 The Authors. Published by Elsevier Ltd. This is an open access article under the CC BY-NC-ND license (https://creativecommons.org/licenses/by-nc-nd/4.0/) Selection and peer-review under responsibility of the International Scientific Committee of the 8th CIRP Conference on High Performance Cutting (HPC 2018). |
URI: | http://hdl.handle.net/2433/244155 |
DOI(出版社版): | 10.1016/j.procir.2018.08.225 |
出現コレクション: | 学術雑誌掲載論文等 |

このリポジトリに保管されているアイテムはすべて著作権により保護されています。