|タイトル:||High-precision machining by measurement and compensation of motion error|
|著者:||Kono, Daisuke |
|引用:||Daisuke Kono, Atsushi Matsubaraa, Iwao Yamaji and Tomoya Fujita. High-precision machining by measurement and compensation of motion error. 48(10), 2008, 1103-1110.|
|誌名:||International Journal of Machine Tools and Manufacture|
|抄録:||This paper describes a systematic method to model and compensate geometric errors of machine tools. In order to separate geometric errors from other errors, measured errors are analyzed in the frequency domain by using the Fourier series. Then, the frequency components corresponding to geometric errors are selected based on the repeatability of their wavelength. Finally, the components are reconstructed and forwarded for the compensation by a fine motion drive. A CNC machine tool with a fine motion mechanism on the Z-axis was developed to compensate the error components in the Z direction on the XY plane. A flat surface machining with non-rotational cutting tools was tested to validate our approach. On the plane of 45 mm×70 mm, the fluctuation of the relative displacement was reduced from 1.3 to 0.5 μm P-V. Machining experiments with a single-crystal diamond tool were also carried out and the straightness of the profile curve was reduced from 1.0 to 0.4 μm. The result of the experiments showed that the geometric errors were compensated separately from the vibration due to the bending mode of the machine column.|
|著作権等:||Copyright © 2008 Elsevier|
この論文は出版社版でありません。引用の際には出版社版をご確認ご利用ください。This is not the published version. Please cite only the published version.