このアイテムのアクセス数: 152

このアイテムのファイル:
ファイル 記述 サイズフォーマット 
j.epsl.2022.117888.pdf4.5 MBAdobe PDF見る/開く
完全メタデータレコード
DCフィールド言語
dc.contributor.authorLin, Weirenen
dc.contributor.authorYamamoto, Yuhjien
dc.contributor.authorHirose, Takehiroen
dc.contributor.alternative林, 為人ja
dc.contributor.alternative山本, 裕二ja
dc.contributor.alternative廣瀬, 丈洋ja
dc.date.accessioned2022-11-16T07:55:07Z-
dc.date.available2022-11-16T07:55:07Z-
dc.date.issued2023-01-01-
dc.identifier.urihttp://hdl.handle.net/2433/277281-
dc.description東北地方太平洋沖地震を引き起こしたプレート境界断層より以深の応力状態を初めて決定 --海洋底掘削で採取されたコア試料の非弾性ひずみ解析からのアプローチ--. 京都大学プレスリリース. 2022-11-11.ja
dc.descriptionFinding faults deeply stressful: First investigation of stress state below plate boundary fault of Tohoku earthquake. 京都大学プレスリリース. 2022-12-09.en
dc.description.abstractThe Integrated Ocean Drilling Program conducted Expedition 343 and 343T, named the Japan Trench Fast Drilling Project (JFAST), to drill through the plate boundary fault that ruptured during the 2011 Mw 9.0 Tohoku earthquake in the area with the largest fault slip displacement near the Japan trench. Analyses of breakouts observed from borehole C0019B produced postearthquake stress states above the plate boundary fault between the subducting Pacific plate and overriding North American plate. To supplement the lack of stress data below the rupture zone of the earthquake, we conducted core-based three-dimensional stress measurements by the anelastic strain recovery (ASR) method using four whole-round core samples of sediments, of which three samples were located above, but one sample was located below the plate boundary fault in borehole C0019E. As a result of the stress measurements, the postearthquake three-dimensional stress magnitudes at ∼802 and ∼828 meters below seafloor (mbsf) across the plate boundary fault at ∼820 mbsf reveal a normal faulting stress regime. The differences between the three-dimensional intermediate principal stress and the minimum principal stress at the two depths are less than 1 MPa, suggesting a complete release of horizontal tectonic stresses that accumulated before the earthquake. In addition, the maximum horizontal stress S[Hmax] azimuth N115°E at ∼828 mbsf below the plate boundary fault from ASR measurements shows consistency with the S[Hmax] azimuth N139 ± 23°E (mean ± standard deviation) at ∼550–810 mbsf from breakout analyses above the fault. Taken together with the similar stress magnitudes at ∼802 and ∼828 mbsf, we interpret that the postearthquake stress states are almost the same in the sediments above and below the plate boundary fault. In other words, the stress state in terms of both orientation and magnitude is continuous across the fault. At a shallower depth of ∼177 mbsf in the slope sediments, the ASR stress data reveal a “stress state at rest”, which is likely free from tectonic effects of plate subduction, suggesting that the stress state was reset by the great coseismic displacement of ∼50 m slipped during the Tohoku earthquake.en
dc.language.isoeng-
dc.publisherElsevier BVen
dc.rights© 2022 The Author(s). Published by Elsevier B.V.en
dc.rightsThis is an open access article under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International license.en
dc.rights.urihttps://creativecommons.org/licenses/by-nc-nd/4.0/-
dc.subjectTohoku earthquakeen
dc.subjectthree-dimensional stress stateen
dc.subjectabove and below plate boundary faulten
dc.subjectanelastic strain recoveryen
dc.subjectJFASTen
dc.subjectIODPen
dc.titleThree-dimensional stress state above and below the plate boundary fault after the 2011 Mw 9.0 Tohoku earthquakeen
dc.typejournal article-
dc.type.niitypeJournal Article-
dc.identifier.jtitleEarth and Planetary Science Lettersen
dc.identifier.volume601-
dc.relation.doi10.1016/j.epsl.2022.117888-
dc.textversionpublisher-
dc.identifier.artnum117888-
dc.addressGraduate School of Engineering, Kyoto Universityen
dc.addressCenter for Advanced Marine Core Research, Kochi Universityen
dc.addressKochi Institute for Core Sample Research (X-star), Japan Agency for Marine-Earth Science and Technology (JAMSTEC)en
dc.relation.urlhttps://www.t.kyoto-u.ac.jp/ja/research/topics/20221115-
dc.relation.urlhttps://www.kyoto-u.ac.jp/en/research-news/2022-12-09-
dcterms.accessRightsopen access-
datacite.awardNumber25287134-
datacite.awardNumber19H00717-
datacite.awardNumber.urihttps://kaken.nii.ac.jp/grant/KAKENHI-PROJECT-25287134/-
datacite.awardNumber.urihttps://kaken.nii.ac.jp/grant/KAKENHI-PROJECT-19H00717/-
dc.identifier.pissn0012-821X-
dc.identifier.eissn1385-013X-
jpcoar.funderName日本学術振興会ja
jpcoar.funderName日本学術振興会ja
jpcoar.awardTitle東北巨大地震断層近傍の応力状態:「ちきゅう」による日本海溝掘削からのアプローチja
jpcoar.awardTitle熊本地震時における震源断層の摩擦熱定量評価と特異な温度構造の解明ja
出現コレクション:学術雑誌掲載論文等

アイテムの簡略レコードを表示する

Export to RefWorks


出力フォーマット 


このアイテムは次のライセンスが設定されています: クリエイティブ・コモンズ・ライセンス Creative Commons