ダウンロード数: 21
このアイテムのファイル:
| ファイル | 記述 | サイズ | フォーマット | |
|---|---|---|---|---|
| mfeku_24_3_301.pdf | 703.23 kB | Adobe PDF | 見る/開く |
| タイトル: | Machinability of Cast Iron |
| 著者: | OKUSHIMA, Keiji IWATA, Kazuaki NAKATOMI, Itsuro KURIMOTO, Takeshi |
| 発行日: | 31-Aug-1962 |
| 出版者: | Faculty of Engineering, Kyoto University |
| 誌名: | Memoirs of the Faculty of Engineering, Kyoto University |
| 巻: | 24 |
| 号: | 3 |
| 開始ページ: | 301 |
| 終了ページ: | 314 |
| 抄録: | The machinability of cast iron was investigated from the standpoint of chip formation, tool life, and surface finish. Cutting mechanisms of cast iron were analysed based upon the flow region concept. The effects of feed and rake angle on the cutting process were discussed. The most suitable tool material for cutting cast iron was selected and effects of cutting conditions on tool life were investigated over a wide range. Machinability based upon surface finish is discussed in connection with tool wear. |
| URI: | http://hdl.handle.net/2433/280528 |
| 出現コレクション: | Vol.24 Part 3 |
このリポジトリに保管されているアイテムはすべて著作権により保護されています。