ダウンロード数: 842
このアイテムのファイル:
ファイル | 記述 | サイズ | フォーマット | |
---|---|---|---|---|
frk_060_219.pdf | 796.83 kB | Adobe PDF | 見る/開く |
タイトル: | 中国製チェーンソーの特性について |
その他のタイトル: | On the characteristics of the chainsaw made in CHINA |
著者: | 瀧本, 義彦 黄, 箭波 |
著者名の別形: | Takimoto, Yoshihiko Kou, Senpa |
発行日: | 2-Dec-1988 |
出版者: | 京都大学農学部附属演習林 |
誌名: | 京都大学農学部演習林報告 |
巻: | 60 |
開始ページ: | 219 |
終了ページ: | 231 |
抄録: | 中国製チェーンソーCH25型の振動, 騒音, 出力特性, 燃料消費率を測定して, 他の中国製チェーンソー及びわが国でよく使われているチェーンソーと比較した。その結果, 次のことが判った。(1) 振動加速度は後ハンドル・上下方向の値が飛び抜けて大きく, 最大15. 9gが測定された。この値は中国製チェーンソーの振動加速度17. 3g (YJ4型, 前ハンドル・上下方向, 鋸断時, 4000rpm) よりは小さいが, 余り差は無いといえる。(2) 前ハンドル・後ハンドル共に金属がそのままむき出しにされており, 防振ゴムによるカバーが望ましい。また, 防振構造も改良することにより振動の低下が可能と思える。(4) 騒音は最大112dBでわが国で使われているチェーンソーよりおよそ3 - 9dB大きい。マフラーの改良が望ましい。(5) 出力特性は数値的にはわが国の同クラスのチェンソーと変わらないが, 燃料消費率が高いことから考えて, 気化器の改良が望ましい。 We measured the vibration, noise, power and fuel consumption about the chainsaw (CH25 type) made in China, and the following results were obtained. Vibration : The maximum value of vibration was 15.9g in the up & down direction at the rear handle. This value is undesirable for a chainsaw. Noise : The maximum value of noise was 112dB in cutting. This value is about 3-9dB larger than normal type chainsaws used in Japan. Power : The maximum value of power was 2.43ps at a speed of 7500rpm. This value is similar to the power of a 50cc class chainsaw in Japan. Fuel consumption : The minimum value is 495gr/ps. h at a speed of 6500rpm. This value is 80gr/ps. h larger than same class chainsaws. Comment : Front and rear handles should be covered over by an isolation material (for example rubber). The anti-vibration system, especially the connect elements to the rear end, should be improved. The mechanism of muffler system should be improved. The characteristics of carburetor should be improved. |
URI: | http://hdl.handle.net/2433/191906 |
出現コレクション: | 第60号 |
このリポジトリに保管されているアイテムはすべて著作権により保護されています。